What are the symptoms of Bertazzoni Dishwasher Error Code E11?

Dishwasher fails to fill with water during the wash cycle Error code E11 displays on the control panel Wash cycle starts but stops prematurely No water spraying from spray arms Incomplete or poor cleaning results Dishwasher runs but produces no water sounds

What can I safely check before calling a technician for Bertazzoni Dishwasher Error Code E11?

Check that the main water shutoff valve behind or under the dishwasher is fully turned on (counterclockwise) Verify the household main water supply valve is open and water pressure is adequate Inspect the inlet hose for visible kinks, cracks, or damage along its entire length Ensure the inlet hose connections are tight at both the water source and dishwasher entry point Turn off the dishwasher and unplug it from the outlet, wait 60 seconds, then plug back in and power on to reset Check if your home's circuit breaker for the dishwasher has tripped and reset it if necessary Clean or replace the water inlet filter screen by locating the inlet valve access point (consult your manual for specific location) Verify the dishwasher door is fully closed and properly latched Run a test cycle with the dishwasher empty to confirm whether water enters the tub Check if other household water fixtures are functioning normally to rule out a main supply issue

Error Detected May 1, 2026

Error Code

Bertazzoni Dishwasher Error Code E11

Error code E11 typically indicates a water inlet or fill valve malfunction on Bertazzoni dishwashers sold in the USA. This error means the dishwasher is not receiving adequate water supply or the inlet valve is not operating correctly.

Book a Repair Ask an Expert

Quick Diagnostics

Signs 6 identified

Possible Causes 10 listed

Safety Checks 10 steps

If unsure, stop using the appliance and contact a certified technician immediately.

01

• Dishwasher fails to fill with water during the wash cycle
02

• Error code E11 displays on the control panel
03

• Wash cycle starts but stops prematurely
04

• No water spraying from spray arms
05

• Incomplete or poor cleaning results
06

• Dishwasher runs but produces no water sounds

• Water inlet valve malfunction or failure

• Clogged or kinked inlet water hose

• Water supply turned off at the main shutoff valve

• Low household water pressure below minimum 20 PSI requirement

• Faulty water inlet solenoid coil

• Debris or mineral buildup in the inlet valve filter screen

• Defective water level sensor

• Electronic control board failure

• Loose or corroded electrical connections at the inlet valve

• Main water supply line blockage or restriction

1

• Check that the main water shutoff valve behind or under the dishwasher is fully turned on (counterclockwise)
2

• Verify the household main water supply valve is open and water pressure is adequate
3

• Inspect the inlet hose for visible kinks, cracks, or damage along its entire length
4

• Ensure the inlet hose connections are tight at both the water source and dishwasher entry point
5

• Turn off the dishwasher and unplug it from the outlet, wait 60 seconds, then plug back in and power on to reset
6

• Check if your home's circuit breaker for the dishwasher has tripped and reset it if necessary
7

• Clean or replace the water inlet filter screen by locating the inlet valve access point (consult your manual for specific location)
8

• Verify the dishwasher door is fully closed and properly latched
9

• Run a test cycle with the dishwasher empty to confirm whether water enters the tub
10

• Check if other household water fixtures are functioning normally to rule out a main supply issue

Always unplug the appliance before performing any physical check. These are visual/external checks only.

Still having trouble?

Our certified technicians diagnose and fix this error code permanently.

Schedule a Repair Call Us Now

Bertazzoni Dishwasher Error Code E11

Signs

Possible Causes

Safety Checks You Can Do