Error Detected May 1, 2026
Error Code

Bertazzoni Dishwasher Error Code E7

Error code E7 indicates a water supply or inlet valve malfunction on your Bertazzoni dishwasher. This error typically means the appliance is unable to detect adequate water flow or pressure during the fill cycle.

Book a Repair Ask an Expert
Quick Diagnostics
Signs 7 identified
Possible Causes 9 listed
Safety Checks 9 steps
If unsure, stop using the appliance and contact a certified technician immediately.
What you notice

Signs

7
  • 01
    • Dishwasher fails to fill with water during wash cycle
  • 02
    • E7 error code displayed on control panel
  • 03
    • Wash cycle stops prematurely
  • 04
    • Water pressure seems weak or absent inside the tub
  • 05
    • Dishwasher may run but dishes remain unwashed
  • 06
    • No water draining or very slow drainage
  • 07
    • Audible clicking sounds from inlet valve area
Why it happens

Possible Causes

9
A
• Clogged or kinked inlet hose restricting water flow
B
• Water supply valve (under sink) turned off or partially closed
C
• Faulty water inlet valve unable to open properly
D
• Sediment or mineral buildup in inlet filter screen
E
• Low water pressure from main supply line (below 20 PSI on 120V USA models)
F
• Defective water level sensor
G
• Loose or corroded electrical connection to inlet valve
H
• Failed fill solenoid valve
I
• Damaged inlet hose connection points at both supply and dishwasher
DIY — No disassembly

Safety Checks You Can Do

9
  1. 1
    • Turn off the dishwasher and unplug it from the electrical outlet for 60 seconds, then plug back in to reset the system
  2. 2
    • Check your home's circuit breaker panel and ensure the dishwasher circuit breaker is in the ON position
  3. 3
    • Locate the water supply valve under your sink (typically a shut-off valve) and verify it is turned fully on (counterclockwise)
  4. 4
    • Inspect the inlet hose connecting your water supply to the dishwasher for any visible kinks, cracks, or bends and straighten if necessary
  5. 5
    • Check that the inlet hose connections are hand-tight at both the water valve and dishwasher inlet point
  6. 6
    • Remove and clean the inlet filter screen located where the hose connects to the dishwasher (consult your user manual for exact location)
  7. 7
    • Ensure the dishwasher door is fully closed and latches completely with a clicking sound
  8. 8
    • Run a short test cycle with the door closed to see if water fills normally
  9. 9
    • If error persists, contact a qualified Bertazzoni service technician as internal valve replacement may be required
Always unplug the appliance before performing any physical check. These are visual/external checks only.
Still having trouble?

Our certified technicians diagnose and fix this error code permanently.

Schedule a Repair Call Us Now