What are the symptoms of Bertazzoni Dishwasher Error Code E2?

Dishwasher fails to start or fill with water Cycle stops midway through operation Water level inside the tub is noticeably low Error code E2 displays on the control panel Audible alarm or beeping sounds from the appliance No water spraying from wash arms during operation

What can I safely check before calling a technician for Bertazzoni Dishwasher Error Code E2?

Turn off the circuit breaker supplying power to the dishwasher for 60 seconds, then turn it back on to reset the appliance Verify the main water supply valve under your sink is fully turned on (rotate counterclockwise) Inspect both hot and cold water inlet hoses for kinks, twists, or pinches along their entire length Check that inlet hoses are not frozen if you live in a cold climate Locate the inlet hose filter screens (where hoses connect to the dishwasher) and rinse them under running water to remove sediment or debris Ensure the dishwasher door is closing completely and latching firmly with an audible click Listen for water filling sounds when you start the cycle; if you hear nothing, the inlet valve may be faulty Verify your home's water pressure is adequate by checking other faucets; if water pressure is very low throughout your home, contact your water utility Do not attempt to disassemble or replace the inlet valve yourself—this requires professional service

Error Detected May 1, 2026

Error Code

Bertazzoni Dishwasher Error Code E2

Error code E2 indicates a water inlet or fill issue on your Bertazzoni dishwasher. This error means the appliance is not receiving adequate water supply or detecting water flow problems during the fill cycle.

Book a Repair Ask an Expert

Quick Diagnostics

Signs 6 identified

Possible Causes 9 listed

Safety Checks 9 steps

If unsure, stop using the appliance and contact a certified technician immediately.

01

• Dishwasher fails to start or fill with water
02

• Cycle stops midway through operation
03

• Water level inside the tub is noticeably low
04

• Error code E2 displays on the control panel
05

• Audible alarm or beeping sounds from the appliance
06

• No water spraying from wash arms during operation

• Kinked or pinched inlet hose restricting water flow

• Main water supply valve (under sink) turned off or partially closed

• Clogged inlet screen filter at the water supply connection

• Faulty water inlet valve solenoid (120V circuit issue)

• Water pressure too low from municipal supply (common in some USA areas)

• Frozen water supply line (in winter conditions)

• Defective water level sensor or float switch

• Electrical connection issues with the inlet valve

• Door latch not properly engaging, triggering safety shutoff

1

• Turn off the circuit breaker supplying power to the dishwasher for 60 seconds, then turn it back on to reset the appliance
2

• Verify the main water supply valve under your sink is fully turned on (rotate counterclockwise)
3

• Inspect both hot and cold water inlet hoses for kinks, twists, or pinches along their entire length
4

• Check that inlet hoses are not frozen if you live in a cold climate
5

• Locate the inlet hose filter screens (where hoses connect to the dishwasher) and rinse them under running water to remove sediment or debris
6

• Ensure the dishwasher door is closing completely and latching firmly with an audible click
7

• Listen for water filling sounds when you start the cycle; if you hear nothing, the inlet valve may be faulty
8

• Verify your home's water pressure is adequate by checking other faucets; if water pressure is very low throughout your home, contact your water utility
9

• Do not attempt to disassemble or replace the inlet valve yourself—this requires professional service

Always unplug the appliance before performing any physical check. These are visual/external checks only.

Still having trouble?

Our certified technicians diagnose and fix this error code permanently.

Schedule a Repair Call Us Now

Bertazzoni Dishwasher Error Code E2

Signs

Possible Causes

Safety Checks You Can Do