Error Detected May 1, 2026
Error Code

Bertazzoni Refrigerator Error Code E6

Error code E6 on Bertazzoni refrigerators sold in the USA typically indicates a temperature sensor malfunction or communication error between the control board and temperature detection system. This error prevents the refrigerator from accurately monitoring and maintaining proper cooling temperatures.

Book a Repair Ask an Expert
Quick Diagnostics
Signs 8 identified
Possible Causes 8 listed
Safety Checks 8 steps
If unsure, stop using the appliance and contact a certified technician immediately.
What you notice

Signs

8
  • 01
    • Refrigerator not cooling properly or not cooling at all
  • 02
    • Freezer section displaying incorrect temperature readings
  • 03
    • Compressor running continuously without cycling off
  • 04
    • Control panel displaying E6 error code
  • 05
    • Inability to adjust temperature settings through the control interface
  • 06
    • Warm air blowing from vents despite temperature dial settings
  • 07
    • Frost buildup or excessive ice formation in freezer compartment
  • 08
    • Food spoiling faster than normal
Why it happens

Possible Causes

8
A
• Faulty temperature sensor in the evaporator coil or fresh food section
B
• Loose or disconnected wiring harness between sensor and control board
C
• Defective thermistor (temperature detection component)
D
• Control board malfunction preventing sensor signal interpretation
E
• Damaged temperature probe in refrigerator or freezer section
F
• Poor electrical connection at 120V supply affecting sensor circuit
G
• Ice accumulation on temperature sensor blocking accurate readings
H
• Failed sensor due to manufacturing defect or age-related wear
DIY — No disassembly

Safety Checks You Can Do

8
  1. 1
    • Verify the refrigerator is plugged into a functioning 120V outlet and check that the circuit breaker for the outlet has not tripped
  2. 2
    • Ensure both refrigerator and freezer doors are fully closed and the door seals are making proper contact without gaps
  3. 3
    • Confirm temperature settings are adjusted to recommended levels (typically 37-40°F for refrigerator, 0°F for freezer) and not set to the warmest or coldest positions
  4. 4
    • Check that air vents inside the refrigerator and freezer compartments are not blocked by food items or packaging
  5. 5
    • Ensure the refrigerator has at least 2 inches of clearance on all sides and 4-6 inches of space above for proper airflow
  6. 6
    • Unplug the refrigerator from the electrical outlet and wait 60 seconds to allow the control board to reset, then plug back in and observe if error clears
  7. 7
    • Inspect the back of the refrigerator to ensure the condenser coils and fan are free from dust accumulation
  8. 8
    • Check that the room temperature where the refrigerator is located is between 50°F and 110°F for optimal operation
Always unplug the appliance before performing any physical check. These are visual/external checks only.
Still having trouble?

Our certified technicians diagnose and fix this error code permanently.

Schedule a Repair Call Us Now