Error Detected May 1, 2026
Error Code

Bertazzoni Freezer Error Code E3

Error code E3 indicates a temperature sensor malfunction or communication failure between the freezer's control board and temperature monitoring system. This error prevents the freezer from maintaining proper cooling temperatures and requires diagnostic attention.

Book a Repair Ask an Expert
Quick Diagnostics
Signs 7 identified
Possible Causes 8 listed
Safety Checks 8 steps
If unsure, stop using the appliance and contact a certified technician immediately.
What you notice

Signs

7
  • 01
    • Freezer not reaching proper freezing temperatures
  • 02
    • Display screen shows E3 error code
  • 03
    • Inconsistent temperature readings on digital display
  • 04
    • Compressor running continuously without cycling off
  • 05
    • Food items not freezing properly or thawing unexpectedly
  • 06
    • Audible beeping or alarm sounds from the unit
  • 07
    • Control panel may become unresponsive or freeze
Why it happens

Possible Causes

8
A
• Faulty temperature sensor probe in the freezer compartment
B
• Loose or disconnected wiring harness between sensor and control board
C
• Defective control board unable to process sensor signals
D
• Frost buildup blocking temperature sensor accuracy
E
• Power surge or electrical fluctuation affecting 120V circuit
F
• Failed thermistor component in the temperature sensing circuit
G
• Water damage or corrosion in electrical connections
H
• Software malfunction in the appliance's microprocessor
DIY — No disassembly

Safety Checks You Can Do

8
  1. 1
    • Check that the circuit breaker supplying power to your freezer has not tripped; reset if necessary
  2. 2
    • Ensure the freezer door closes completely and the door seal is not cracked or damaged
  3. 3
    • Verify the freezer temperature setting is not set to the warmest setting; adjust to recommended -4°F to 0°F range
  4. 4
    • Inspect the freezer interior vents for any blockages from food items or excessive frost buildup; remove any obstructions
  5. 5
    • Check that the freezer is not positioned against a wall that blocks rear ventilation; ensure at least 2-3 inches of clearance
  6. 6
    • Power cycle the unit by turning off the circuit breaker for 60 seconds, then turn it back on to reset the control board
  7. 7
    • Ensure the appliance is not in a location with ambient temperatures below 50°F, which can cause sensor malfunctions
  8. 8
    • If error persists after these checks, contact a certified Bertazzoni service technician or authorized USA repair service for sensor replacement
Always unplug the appliance before performing any physical check. These are visual/external checks only.
Still having trouble?

Our certified technicians diagnose and fix this error code permanently.

Schedule a Repair Call Us Now