Error Detected May 1, 2026
Error Code

Bertazzoni Cooktop Error Code E6

Error code E6 on Bertazzoni USA cooktops typically indicates a temperature sensor malfunction or thermal protection activation. This error prevents the cooktop from operating to protect against potential overheating or electrical hazards.

Book a Repair Ask an Expert
Quick Diagnostics
Signs 7 identified
Possible Causes 9 listed
Safety Checks 11 steps
If unsure, stop using the appliance and contact a certified technician immediately.
What you notice

Signs

7
  • 01
    • Cooktop fails to heat or respond to controls
  • 02
    • Display shows E6 error code and cooktop locks out
  • 03
    • Burners will not ignite (gas models) or activate (induction models)
  • 04
    • Controls are unresponsive or grayed out
  • 05
    • Cooktop may shut off unexpectedly during cooking
  • 06
    • Fan runs continuously or intermittently
  • 07
    • Cooktop surface remains cold despite control panel input
Why it happens

Possible Causes

9
A
• Temperature sensor malfunction or sensor wire disconnection
B
• Thermal protection circuit triggered by excessive heat buildup
C
• Faulty temperature control board or PCB component failure
D
• Poor electrical connection or voltage instability (240V line issue)
E
• Cooktop surface overheated from prolonged use or blocked ventilation
F
• Moisture or condensation in sensor connections affecting readings
G
• Defective thermistor or resistance temperature detector (RTD)
H
• Control panel calibration error after power fluctuation
I
• Wiring harness damage between sensor and control board
DIY — No disassembly

Safety Checks You Can Do

11
  1. 1
    • Verify the circuit breaker serving the cooktop is in ON position; check if breaker tripped and reset if necessary
  2. 2
    • Power down the cooktop by switching off the dedicated circuit breaker for 60 seconds, then turn back on to reset the system
  3. 3
    • Allow the cooktop to cool completely (at least 30 minutes) before attempting to use again
  4. 4
    • Inspect the cooktop surface for spills, moisture, or debris and clean thoroughly with a dry cloth
  5. 5
    • Check that all cookware has been removed from the cooktop surface
  6. 6
    • Verify control panel buttons are not stuck and respond normally when pressed
  7. 7
    • For induction models, confirm cookware is ferromagnetic compatible (test with magnet)
  8. 8
    • Ensure cooktop ventilation area is not blocked by kitchen items or curtains
  9. 9
    • Check that the power cord is fully seated in the wall outlet and not damaged
  10. 10
    • Document when the error appears (during specific burner use or all burners) to provide to service technician
  11. 11
    • If error persists after these steps, contact Bertazzoni customer service or a certified USA appliance repair technician for professional diagnostics
Always unplug the appliance before performing any physical check. These are visual/external checks only.
Still having trouble?

Our certified technicians diagnose and fix this error code permanently.

Schedule a Repair Call Us Now